A hardness tester is create with the intend to evaluate the hardness of a material. Hardness tester is an industrial product and used in manufacturing sections. It is also suitable to test the hardness of bulk quantities as well. Hardness tester provide accurate outcome and high performance. To get the correct result a small load pertained to them in order to remove vibration of the material. It can be operate easily and doesn't require any professional knowledge. It can be installed easily but to obtain correct result , handle hardness tester carefully. It is cost effective.
Steps to know How to use a Hardness Tester -
The first and foremost step is to carefully setup a hardness tester. It should be place at right position so that you will get accurate results. Now check the dial by turning the bezel.
After installation of hardness tester turn the hand wheel slowly. Now you will see a minor pressure on the penetrator , don’t get panic it is normal.
It is key step for setting a hardness tester. Spin the barrel dial till its pin gets reset. Always keep in mind that the upper line of a barrel always be equivalent to the hairline of a magnifier. Spin the dial until pin is reset to the upper fringe of magnifier. This will help in achieving an accurate result at short period of time.
To get the appropriate result turn the wheel properly. You can observe the result through magnifying glass. It is easy to operate a hardness tester by using these mentioned steps properly.
By following above mentioned steps , people can easily operate hardness tester. You have to carefully setting up the things because negligence may lead to danger.
Comments
Post a Comment